Car Seat Modification - Car Modification Of The Production Of Leather Seats In The Car

Especially reflected in the car, many friends are buying luxury cars on the basis of economic conditions. And even if you buy a general car, then the friends of the car family will make the interior of the car a "rich and magnificent" to highlight its own personality. The modification of the leather seat of the car interior modification in the car interior modification is still the most common. The making of the leather chair is the most basic and important work. It is an important indicator to measure the quality of the leather chair. Below we modify the car interior according to our own experience and leak: the leather seat manufacturing process

     The first step is to cut the skin. A piece of cowhide is about 40 to 50 square feet. The leather and leather surface of the cow's back is the best part of the leather. It is generally used for the backrest and seat cushion of the seat. Because the two parts of the seat are under pressure and friction for a long time, it is also the most susceptible part. . The skin of the beef belly and the cow neck is poor. It is generally used for the skirt of the seat or the part that is not easy to see. The leather has the same stretching direction as the cloth. Some leather chairs sit for a month or two. Concavities and bumps occur, mostly due to improper orientation of the skin.

      The second step is sewing. After the leather is cut, it enters the sewing process. There is also some emphasis here. Under the general leather, a 12 to 15 mm thick sponge with a mesh bottom is also called super-powerful cotton. Note that some shops are cutting corners here. When sewing, it is very important for the worker to be familiar with the hand. Once the leather is stitched, it can't be changed again. Otherwise, it will leave obvious pinholes on the leather. When checking, pay attention to whether the stitch length of the open thread is even and whether the leather head is there. Exposed, with or without burrs and thread ends, whether the line and leather color are the same.

       The third step, the set seat, is simply to put the sewed holster on the seat. It's simple to say, it's not so easy to do. In the suit, the leather case will be torn or scratched if it is slightly inadvertent. After putting it on, the leather case should be affixed to the seat by tapping and pulling. The staple of the fixed leather case should be rust-proof. The size and tightness of the nail distribution should be consistent. When assembling the seat, the joint between the seat cushion and the cushion should be symmetrical.

      The fourth step is to reload the seat. The space inside the door and the car is limited, the size of the seat is not small, and it is relatively heavy. When reloading, it is necessary to avoid scratching the seat surface and not touching the paint, so it must be done according to the requirements of the reloading process. Otherwise, If you are not careful, you will lose all your efforts.