Here I teach a few simpler methods to dismantle. Or avoid your problem.
1. Method 1: Demolition of GPS. Sany's on the instrument panel, Hitachi's computer board behind the seat, Longgong's seat behind the cab; Method 2: squatting by a magnet. Some excavators In the case you don't know. There is also the easiest way. Isn't GPS having a signal receiver on the roof? Put a few large magnets next to the receiver to ignite the magnetic field so that he can't accept the signal. These things are not to teach everyone how to escape the problem. Instead, they are self-dissolving in the event of an unreasonable situation.
2 .kinds of things, I hope that everyone is best not to operate, the so-called GPS positioning, and then to the engine automatically extinguished, in fact, it is white computer control to cut off your electric flameout switch. Then turn off the fire for you, you can't start without it. Then my door has the most direct way to do this, and the electric air-extinguishing switch is removed and changed to manual control.
The simple disassembly and assembly method of the pine excavator GPS, the GPS fixed and remote control module of the Komatsu excavator is installed next to a computer integrated block (computer board) inside the display on the right side of the cab. When you dismantle it, there is a Automatic alarm sensing device. It is necessary to first remove the set of power cables. From the computer integrated block (computer board), there are 4 leads (two groups) connected to the GPS module, one is the power cable and the other is the signal cable. It is enough to remove the set of power cords. If you don't understand the circuit, don't just disassemble it. If you don't get it, chances are automatically locked.
The detailed demonstration of the process of dismantling will not be explained one after another. The tool to be removed is very simple. Only three 5 cm long wires of 15 cm long and one digging light bulb are needed. The 12V digging is 24V.
